Service manual

5-22

Intrepid® 6064 Director Installation and Service Manual

Removal and Replacement Procedures (RRPs)

RRP: Filler Blank (UPM)

Use the following procedures to remove or replace a UPM filler

blank. Filler blanks cover and protect unused port card slots in the

directorchassis.A list of tools required is provided.

Tools Required The following tools are required to perform these procedures.

• Door key with 5/16-inch socket (provided with the FC-512

Fabricenter equipment cabinet).

• Torque tool and hex adapter (provided with the director).

Removal To remove a filler blank:

1. If the director is installed in a stand-alone configuration, go

to step 2. If the director is rack-mounted, perform one of the

following:

— If the director is installed in a McDATA-supplied FC-512

Fabricenter equipment cabinet, insert the 5/16" door tool into

the socket hole at the right top of the front door. Turn the tool

counter-clockwise to unlock and open the door.

— If the director is installed in a customer-supplied equipment

cabinet, unlock and open the cabinet front door as directed by

the customer representative.

2. Identify the filler blank to be removed.

3. The filler blank is secured to the director chassis with two captive

Allen screws. Both screws are spring-loaded to lock the filler

blank in place.

4. Insert the torque tool into each locking Allen screw (Figure 5-7).

Turn each screw counter-clockwise until the spring releases and

the tool turns freely.

5. Pull the filler blank out and remove it from the director chassis.