Service manual

5-18

Intrepid® 6064 Director Installation and Service Manual

Removal and Replacement Procedures (RRPs)

RRP: Optical Transceiver (SFP)

Use the following procedures to remove or replace an SFP optical

transceiver from a UPM card. A list of tools required is provided.

Tools Required The following tools are required to perform these procedures.

• Door key with 5/16-inch socket (provided with the FC-512

Fabricenter equipment cabinet).

• ESD grounding cable and wrist strap.

• Fiber-optic protective plug (provided with the director).

• Protective cap (provided with the fiber-optic jumper cable).

• Fiber-optic cleaning kit.

Removal To remove an SFP optical transceiver:

1. Notify the customer that the port with the defective transceiver

will be blocked. Ensure the customer system administrator sets

the attached device offline.

2. If the director is installed in a stand-alone configuration, go to

step 3. If the director is rack-mounted, perform one of the

following:

— If the director is installed in a McDATA-supplied FC-512

Fabricenter equipment cabinet, insert the 5/16" door tool into

the socket hole at the right top of the front door. Turn the tool

counter-clockwise to unlock and open the door.

— If the director is installed in a customer-supplied equipment

cabinet, unlock and open the cabinet front door as directed by

the customer representative.

3. Identifythe defective port transceiver from the amberLED on the

port card or failure information at the management server Port

Card View.

4. Block communication to the port (Downloading Director Firmware

and Software on page 4-41).

5. Follow ESD procedures by attaching a wrist strap to the director

chassis and your wrist (Figure 5-1).

6. Disconnect the fiber-optic jumper cable from the port:

a. Pull the keyed LC free from the port optical transceiver.