Service manual

5
RRP: CTP2 Card
5-9
Removal and Replacement Procedures (RRPs)
5. The CTP2 card is secured to the director chassis with two captive
Allen screws. The bottom screw is spring-loaded and locks the
CTP2 card in place. The top screw cams the CTP2 card into and
out of the backplane.
ATTENTION! The torque tool supplied with the Intrepid 6064 Director is
designed to tighten director logic cards and is set to release at a torque value
of six inch-pounds. Do not use an Allen wrench or torque tool designed for
use with another McDATA product. Use of the wrong tool may overtighten
and damage logic cards.
a. Insert the torque tool into the locking Allen screw at the
bottom of the card. Turn the screw counter-clockwise until the
spring releases and the tool turns freely.
b. InsertthetorquetoolintothecamAllenscrewatthetop of the
card (Figure 5-4). To unseat the CTP2 card and cam it out of
the backplane, turn the screw counterclockwise until the tool
turns freely.
Figure 5-4 CTP2 Card Removal and Replacement
6. Pull the CTP2 card from its card track and remove it from the
director chassis. Place the card in an anti-static bag to provide
ESD protection.
Replacement To replace a CTP2 card: