Service manual

5-8

Intrepid® 6064 Director Installation and Service Manual

Removal and Replacement Procedures (RRPs)

RRP: CTP2 Card

Use the following procedures to remove or replace a CTP2 card(two

cards in the director) with the backup CTP2 card operational. A list of

toolsrequiredisprovided.

ATTENTION! DonotremoveandreplaceaCTP2cardifthebackupCTP2

cardis notfully operationaland directorpower is on.The directorIP address,

configuration data, and other operating parameters willbe lost.

Tools Required The following tools are required to perform these procedures.

• Door key with 5/16-inch socket (provided with the FC-512

Fabricenter equipment cabinet).

• ESD grounding cable and wrist strap.

• Torque tool and hex adapter (provided with the director).

Removal To remove a CTP2 card:

1. If the director is installed in a stand-alone configuration, go to

step 2. If the director is rack-mounted, perform one of the

following:

— If the director is installed in a McDATA-supplied FC-512

Fabricenter equipment cabinet, insert the 5/16” door tool into

the socket hole at the right top of the front door. Turn the tool

counter-clockwise to unlock and open the door.

— If the director is installed in a customer-supplied equipment

cabinet, unlock and open the cabinet front door as directed by

the customer representative.

2. Follow ESD procedures by attaching a wrist strap to the director

chassis and your wrist (Figure 5-1).

ATTENTION! To avoidcausing machine errorsor damagewhileworkingon

the director, follow ESD procedures by connecting a grounding cable to the

director chassis and wearingan ESD wrist strap.

3. Identify the defective CTP2 card from the amber LED on the card

or failure information at the management server Hardware View.

4. Disconnect the Ethernet local area network (LAN) cable from the

RJ-45 connector on the card faceplate.