Service manual

5
RRP: Cable Management Assembly
5-7
Removal and Replacement Procedures (RRPs)
.
Figure 5-3 Cable Management Assembly Removal and Replacement
Replacement To replace the cable management assembly:
1. Position the cable management assembly at the front of the
director chassis (Figure 5-3).
2. Disengage both captive pins by pulling them inward, then push
the assembly toward the card cage area.
3. Release the captive pins so they engage in the chassis anchor
points.
4. Route fiber-optic and Ethernet cables through the cable
management assembly. Dress the cables evenly through the
assembly cut-out slots.
5. If necessary, close and lock the equipment cabinet door.