Service manual

3
3-46
Intrepid® 6064 Director Installation and Service Manual
Maintenance Analysis Procedures (MAPS)
a. Inform the customer the port will be blocked. Ensure the system
administrator quiesces Fibre Channel frame traffic and sets
attached devices offline.
b. Block the port (
Blocking and Unblocking Ports on page 4-27).
c. Clean fiber-optic connectors (
Cleaning Fiber-Optic Components
on page 4-40).
d. Unblock the port (
Blocking and Unblocking Ports on page 4-27).
e. Monitor port operation for approximately five minutes.
Did the link incident recur?
YES NO
↓ The product port is operational. Exit MAP.
24
Disconnect the fiber-optic jumper cable from the port and connect the
cabletoaspareport.
Is a link incident reported at the new port?
YES NO
↓ The port reporting the problem is causing the link incident.
This indicates port degradation and a possible pending
failure. Go to step 20.
25
Ensure the attached fiber-optic jumper cable is not bent and
connectors are not damaged. If the cable is bent or connectors are
damaged:
a. Inform the customer the port will be blocked. Ensure the system
administrator quiesces Fibre Channel frame traffic and sets
attached devices offline.
b. Block the port (
Blocking and Unblocking Ports on page 4-27).
c. Remove and replace the fiber-optic jumper cable.
d. Unblock the port (
Blocking and Unblocking Ports on page 4-27).
Was the maintenance action successful?
NO YES
↓ The product port is operational. Exit MAP.