System information
Table Of Contents
- Cover
- Preface
- Overview
- Configuring System Basics
- Configuring RADs and mSAN Connections
- Configuring iSAN Connections
- Configuring iSCSI Connections
- Monitoring SAN Router Operation and Connections
- Configuration, Firmware, and System Log Maintenance
- Troubleshooting
- Glossary
- Index
4
Configuring iSAN Connections
4-17
Configuring iFCP Connections
NOTE: Backup connections (identified by Backup in the Connection column)
cannot be selected, even when the backup connection is active. Backup
connections cannot be edited or removed. These connections inherit their
settings from the corresponding primary connection.
CAUTION
When exporting zones across iFCP, make sure the zone members
are device WWNs and not fabric ports, as fabric port zones are not
supported across iFCP.
To configure an iFCP connection going to a remote SAN Router,
follow these instructions:
1. Click Add on the Remote Connections dialog box to display the Add
Remote Connections dialog box (
Figure 4-7).