System information
Table Of Contents
- Cover
- Preface
- Overview
- Configuring System Basics
- Configuring RADs and mSAN Connections
- Configuring iSAN Connections
- Configuring iSCSI Connections
- Monitoring SAN Router Operation and Connections
- Configuration, Firmware, and System Log Maintenance
- Troubleshooting
- Glossary
- Index
4
4-6
Eclipse™ 2640 SAN Router Administration and Configuration Manual
Configuring TCP Ports for iFCP
6. Select the Flash LED option to blink the port LED. You can use
this option to locate the physical port in a rack of SAN Routers.
Setting the Advanced TCP Parameters
The SAN Router provides options to optimize the TCP port behavior
through a set of advanced parameters. Use the following procedure
to configure the advanced TCP parameters.
1. Click the Advanced button. The Advanced TCP Configuration dialog
box appears (
Figure 4-3 on page 4-6).
Figure 4-3 Advanced TCP Configuration
In the TCP section:
•Select Auto-reset port on severe errors especially when the port is
a part of a mission-critical configuration.