System information
Table Of Contents
- Cover
- Preface
- Overview
- Configuring System Basics
- Configuring RADs and mSAN Connections
- Configuring iSAN Connections
- Configuring iSCSI Connections
- Monitoring SAN Router Operation and Connections
- Configuration, Firmware, and System Log Maintenance
- Troubleshooting
- Glossary
- Index
3
3-4
Eclipse™ 2640 SAN Router Administration and Configuration Manual
Configuring the FC Ports for Router-Attached Devices
Configuring the FC Ports for Router-Attached Devices
This section describes how to configure the Fibre Channel ports on
the SAN Router as R_Ports for attaching directly to an Fibre Channel
device. To configure R_Ports for attaching to an Fibre Channel switch
(mSAN), refer to
Configuring R_Ports for mSANs on page 3-6.
1. Select Configuration>Port>FC/Ethernet to display the FC/Ethernet
Port Configuration dialog box (
Figure 3-1 on page 3-4).
Figure 3-1 FC/Ethernet Port Configuration Dialog Box
2. Select an Fibre Channel port (1-12) from the Port number list.