System information
Table Of Contents
- Cover
- Preface
- Overview
- Configuring System Basics
- Configuring RADs and mSAN Connections
- Configuring iSAN Connections
- Configuring iSCSI Connections
- Monitoring SAN Router Operation and Connections
- Configuration, Firmware, and System Log Maintenance
- Troubleshooting
- Glossary
- Index
2
2-30
Eclipse™ 2640 SAN Router Administration and Configuration Manual
Configuring System Operations
Configuring SNMP
To configure the SNMP communities and hosts, follow these
instructions:
1. Select Configuration>System>SNMP Communities/Hosts to display
the SNMP Communities/Hosts dialog box (
Figure 2-14 on
page 2-30).
Figure 2-14 SNMP Communities/Hosts Dialog Box
2. Type the read-only password and read-modify password
(community strings) for the SAN Router.
3. Optionally, enter a list of IP addresses from which the SAN
Router is authorized to accept SNMP requests.
• If you leave the list empty, SNMP requests are accepted from
any management station.
• If you make at least one entry in the table, SNMP requests are
accepted only from addresses included in the table.
4. Click OK or Apply.