System information
Table Of Contents
- Cover
- Preface
- Overview
- Configuring System Basics
- Configuring RADs and mSAN Connections
- Configuring iSAN Connections
- Configuring iSCSI Connections
- Monitoring SAN Router Operation and Connections
- Configuration, Firmware, and System Log Maintenance
- Troubleshooting
- Glossary
- Index
2
2-26
Eclipse™ 2640 SAN Router Administration and Configuration Manual
Configuring System Operations
The values set take effect only after the SAN Router R_Ports are
disabled and enabled (re-initialized).
NOTE: Changing the cluster ID changes the registered virtual switch node
WWN. This may require the management applications to re-discover the
SAN Router.
Procedure
To set the cluster ID, follow these instructions:
1. Select Configuration>System>Operations to display the System
Operations dialog box.
Figure 2-11 System Operations Dialog Box
2. Enter a number for the cluster ID, in the range 1-63.
3. If you want to enable remote access via Telnet, select the option.
4. Click OK or Apply.
5. Choose Save Configuration from the File tab to permanently save
your changes to the runtime configuration. This saves the
currently running configuration to flash memory.