System information
Table Of Contents
- Cover
- Preface
- Overview
- Configuring System Basics
- Configuring RADs and mSAN Connections
- Configuring iSAN Connections
- Configuring iSCSI Connections
- Monitoring SAN Router Operation and Connections
- Configuration, Firmware, and System Log Maintenance
- Troubleshooting
- Glossary
- Index
7
7-8
Eclipse™ 2640 SAN Router Administration and Configuration Manual
Factory Default Settings for the SAN Router
Factory Default Settings for the SAN Router
The following table lists the default settings for parameters that you
can configure through the SAN Router Element Manager dialog
boxes and the menu path for changing these settings.
Table 7-3 Default Element Manager Parameter Settings
Parameter Default Setting Menu Path
System
SAN Routing Cluster ID 1 Configuration>System>Operations
Enable remote access via Telnet Enabled Configuration>System>Operations
Router Inband address 0.0.0.0 Configuration>System>Inband Address
Router Subnet mask 0.0.0.0 Configuration>System>Inband Address
Default Gateway address 0.0.0.0 Configuration>System>Inband Address
SNMP Read-only Password public Configuration>System>SNMP Communities/Hosts
SNMP Read-modify Password private Configuration>System>SNMP Communities/Hosts
SNMP hosts None defined Configuration>System>SNMP Communities/Hosts
SNMP Traps None defined Configuration>System>SNMP Traps
SNTP Disabled Configuration>System>Date/Time
New Device Zoning Not a member of any
router zone
Configuration>System>New Device Zoning
Element Manager Poll Interval (in seconds) 30 Options>Poll Interval
10/100 BaseT Management Port
Management Port IP address 0.0.0.0
a
*See note ‘a’ following
this table.
Configuration>Port>Management
Management Port Subnet Mask 0.0.0.0 Configuration>Port>Management
Default Gateway 0.0.0.0 Configuration>Port>Management
Multi-function Ports
General