System information
Table Of Contents
- Cover
- Preface
- Overview
- Configuring System Basics
- Configuring RADs and mSAN Connections
- Configuring iSAN Connections
- Configuring iSCSI Connections
- Monitoring SAN Router Operation and Connections
- Configuration, Firmware, and System Log Maintenance
- Troubleshooting
- Glossary
- Index
7
7-6
Eclipse™ 2640 SAN Router Administration and Configuration Manual
Resetting the System
Resetting the System
Certain configuration changes require you to reset the SAN Router
before the changes take effect. Use File>Reset System from the Element
Manager Window. These occurrences are described in previous
chapters and are listed below for reference.
Selecting Reset System from the File menu displays the Reset Options
dialog box (
Figure 7-3).
Figure 7-3 Reset Options Dialog Box
Table 7-2 Resetting the System
Dialog Box Parameter Changed Requiring Reset
Inband Address Configuration
Configuration>System>Inband Address
The Router’s inband address, subnet mask address, and gateway
address.
Advanced FC Port Configuration
Configuration>Por t>Advanced FC Port
The error detection and resource allocation timeout values.
Firmware Upgrade
File>Firmware Upgrade
The activate boot location.
FC/Ethernet Port Configuration
Configuration>Por t>FC/Ethernet
The TCP port address, subnet mask, next hop gateway address,
internal address
iFCP Setup
Configuration>iFCP>Setup
The local mSAN ID.
Management Port Configuration
Configuration>Por t>Management
The management address and subnet mask address.