System information
Table Of Contents
- Cover
- Preface
- Overview
- Configuring System Basics
- Configuring RADs and mSAN Connections
- Configuring iSAN Connections
- Configuring iSCSI Connections
- Monitoring SAN Router Operation and Connections
- Configuration, Firmware, and System Log Maintenance
- Troubleshooting
- Glossary
- Index
6
6-36
Eclipse™ 2640 SAN Router Administration and Configuration Manual
Viewing Statistics
2. Click the Options button to display the Chart Options dialog box
(
Figure 6-26 on page 6-36). Use this dialog box to change the
polling interval and the number of displayed intervals. The
default polling interval is five (5) seconds.
Figure 6-26 Chart Options Dialog Box
NOTE: The polling interval and chart options are saved if you close and
reopen the Remote Connection Statistics report and when you close
Element Manager for this SAN Router and log in later. However, if you
switch the web browser to another web page and back, the polling
interval and chart options reverts to the default value unless cookies are
enabled in the web browser.
3. Click seconds or minutes, and then use the arrow keys or mouse to
adjust the slide bars to change the poll interval or number of
displayed intervals. The charts in the Remote Connection Statistics
report are updated at each poll.
4. Select the charts you want to display.
5. Click Apply. Click OK to close the Chart Options dialog box.
6. Click Close to close the report screen.