System information
Table Of Contents
- Cover
- Preface
- Overview
- Configuring System Basics
- Configuring RADs and mSAN Connections
- Configuring iSAN Connections
- Configuring iSCSI Connections
- Monitoring SAN Router Operation and Connections
- Configuration, Firmware, and System Log Maintenance
- Troubleshooting
- Glossary
- Index
5
5-30
Eclipse™ 2640 SAN Router Administration and Configuration Manual
Configuring iSCSI Authentication
7. Choose Save Configuration to Flash from the File menu to
permanently save the configuration to flash memory.
Configuring the iSCSI Initiator for Authentication
Refer to the documentation of your iSCSI initiator for instructions on
setting up the initiator for CHAP authentication. Following is a
procedure for using the Microsoft iSCSI initiator.
1. Start the Microsoft iSCSI initiator and enter the iSCSI port IP
address on the SAN Router as the target portal address
(
Figure 5-17 on page 5-30).
Figure 5-17 Add Target Portal Dialog Box
2. Click Advanced to display the Advanced Settings dialog box.