System information
Table Of Contents
- Cover
- Preface
- Overview
- Configuring System Basics
- Configuring RADs and mSAN Connections
- Configuring iSAN Connections
- Configuring iSCSI Connections
- Monitoring SAN Router Operation and Connections
- Configuration, Firmware, and System Log Maintenance
- Troubleshooting
- Glossary
- Index
5
Configuring iSCSI Connections
5-13
Configuring iSCSI Devices
Configuring iSCSI Devices
There are two ways to configure a SAN Router with a list of iSCSI
devices (access control list) allowed to connect - Automatic Addition
and Manual Configuration.
To configure devices, select Configuration>iSCSI>Devices. The iSCSI
Devices dialog box appears (
Figure 5-7 on page 5-15).
Figure 5-6 iSCSI Devices Dialog Box
Adding iSCSI Devices Automatically
A convenient way to configure the access control list (iSCSI initiators
only) is to allow the SAN Router to add any iSCSI initiator that
attempts to log in. Each newly discovered device appears in the iSCSI
Devices dialog box (
Figure 5-6 on page 5-13 and Figure 5-7 on
page 5-15) without manual configuration.
To enable automatic configuration of the access control list, select the
Enable Auto Initiator Accept checkbox in the iSCSI Devices dialog box.
In addition, you can enable each iSCSI device registered with the
SAN Router by clicking the checkbox in the Enable column for the
device.