System information

5
5-4
Eclipse™ 2640 SAN Router Administration and Configuration Manual
Configuring iSCSI Ports
iSCSI Configuration Procedures
To configure iSCSI communication with fabrics, follow these steps:
1. Configure the TCP ports for iSCSI. Follow the procedures under
Configuring iSCSI Ports on page 5-4.
2. Configure the iSCSI access control list. Follow procedures under
Configuring iSCSI Devices on page 5-13.
3. Zone the iSCSI devices appropriately using SANvergence
Manager, so the initiators can talk to the targets. Refer to
Zoning
iSCSI Devices on page 5-19.
4. Configure RADIUS server authentication of iSCSI initiators
connected through the SAN Router. Refer to
Configuring iSCSI
Authentication on page 5-25.
Configuring iSCSI Ports
You can configure the TCP ports on the SAN Router (ports 13-16) to
support iSCSI. Configuring the iSCSI ports involves the following
procedures:
1. Configure the general port parameters of the Ethernet ports on
the SAN Router using the procedure
Configuring the General Port
Parameters on page 5-4.
2. Configure the advanced TCP parameters using the procedure
Setting the Advanced TCP Parameters on page 5-6.
3. Configure iSCSI ports on the SAN Router with the procedures
under
Setting the iSCSI parameters on page 5-9.
4. Configure the advanced parameters for the iSCSI ports with the
procedures under
Setting Advanced iSCSI Parameters on page 5-9.
Configuring the General Port Parameters
1. From the Element Manager, select Configuration> Port>
FC/Ethernet.