System information

4
4-26
Eclipse™ 2640 SAN Router Administration and Configuration Manual
Example Configurations and Procedures
2. Enter the default Modify password (private) in the field provided
and click OK.
3. When the Element Manager window appears, select
Configuration>System>Inband Address to change the SAN Router’s
inband address parameters.
• Set the inband address to 192.168.20.131.
When you change the Inband IP address, you must reset the SAN
Router before you can configure the iFCP port.
• Leave the gateway at 0.0.0.0 and click OK.
4. Select Configuration>Ports>FC/Ethernet and select port 13 to
configure the Remote SAN Router’s iFCP port.
•Select iFCP under iSCSI/iFCP Parameters, and enter the
following:
• Port IP- 192.168.27.131
• Subnet Mask- 255.255.255.0
• Next Hop Gateway Address: 0.0.0.0
• Internal Address: 192.168.20.132
•Click OK.
5. Select Configuration>iFCP to display the iFCP Setup dialog box.
•Type 131 for the Local mSAN ID and click OK.
6. Select File>Save Configuration and click OK.
7. Select File>Reset System and click OK.
8. Verify in the Element Manager if the iFCP port is up and showing
a TCP icon on the port, with a green port outline after the SAN
Router comes up again.
9. Log into the Element Manager for the SAN Router with the
192.168.12.130 address.
10. Enter the default Modify password in the field provided (private)
at the login prompt and click Login.
11. When the Element Manager appears, select
Configuration>System>Inband Address to change the SAN Router’s
inband IP address.
• Set the inband address to 192.168.17.130.