System information
Table Of Contents
- Cover
- Preface
- Overview
- Configuring System Basics
- Configuring RADs and mSAN Connections
- Configuring iSAN Connections
- Configuring iSCSI Connections
- Monitoring SAN Router Operation and Connections
- Configuration, Firmware, and System Log Maintenance
- Troubleshooting
- Glossary
- Index
4
Configuring iSAN Connections
4-25
Example Configurations and Procedures
• If the WAN link is severed, separate mSNS servers allow
continued undisturbed communication between initiators and
targets within the local and remote sites.
• When the WAN link is reconnected, communication between the
local and remote devices is automatic and no fabric resets are
necessary to reconverge the network.
A simplified version of this is illustrated in Figure 4-11 on page 4-25.
Figure 4-11 Automatic Communication
To configure this example, follow these steps.
Configuring Ports and Connections
1. Log in into Element Manager for the mSAN with management
port address 192.168.12.131.
NOTE: You can log in through SANvergence Manager or by entering the IP
address into an internet browser.