Service manual

Maintenance and Troubleshooting
5-5
Figure 5-1 Power Supply Removal
Replacement To replace a redundant power supply:
1. Remove the replacement power supply from its shipping
container.
2. Inspect the rear of the power supply for bent or broken connector
pins that may have been damaged during shipping. If any pins
are damaged, obtain a new power supply.
3. Position the power supply in the rear of the router. While
supporting the power supply with one hand, insert it into the
router chassis.
4. Replace the thumb screws.
5. Connect the AC power cord to the power supply and to a facility
power source.
6. Review in either Element Manager or SANvergence Manager to
verify the error has been cleared.
7. If installed in a cabinet, close the equipment cabinet door.