Service manual

Removal and Replacement Procedures
5-1
5
Removal and
Replacement Procedures
Use the links below to access the major topics in this chapter.
Procedural Notes
The following procedural notes are referenced in applicable removal
and replacement procedures.
1. Before removing a FRU, read the removal and replacement
procedures for that FRU carefully and thoroughly to familiarize
yourself with the procedures and reduce the possibility of
problems or customer down time.
2. After completing steps of a detailed procedure that is referenced
from another procedure, return to the initial (referencing)
procedure and continue to the next step of that procedure.
3. After completing a replacement procedure, clear any error
messages reporting the failure and any message reporting the
recovery from the Element Manager or SANvergence Manager
and extinguish the system error (SYS) light-emitting diode (LED)
at the front panel.
Section Page
Procedural Notes 5-1
RRP 1: SFP Optical Transceiver 5-2
RRP 2: Redundant Power Supply 5-4