Service manual

Maintenance and Troubleshooting
3-9
SAN Router Troubleshooting
Review Table 3-2 to troubleshoot SAN Router problems, including
configuration problems, through the Element Manager.
NOTE: Detailed troubleshooting information is available in Administration
and Configuration Manual.
FC/GE Port LED (Ports 1
through 12)
Green and amber This LED is a dual-color (green/amber) LED.
Green indicates GE (Ethernet) and amber indicates FC. Both colors
blink with traffic; the rate of blinking indicates the amount of traffic. If
the LEDs are off, there may be a broken link or the port hardware
may not be working. (If the port is not being used, the LED will be off.)
Errors can also be viewed through the Element Manager or
SANvergence Manager. Refer to
Accessing SNMP Alerts or Alarms
for information on determining problems.
iFCP/iSCSI Port LEDs
(Ports 13 through 16)
Green Intelligent ports, speed 1 Gbps, variable with software settings. Solid
green indicates a link is detected.
Blinking means traffic; the rate of blinking increases with the amount
of traffic. If the LED is off, there may be a broken link.
Errors can also be viewed through the Element Manager or
SANvergence Manager. Refer to
Accessing SNMP Alerts or Alarms
for information on determining problems.
Management Port LED
(10/100)
Green This LED stays on while power is on but does not indicate a link. The
LED blinks when there is traffic.
Errors can also be viewed through the Element Manager or
SANvergence Manager. Refer to
Accessing SNMP Alerts or Alarms
for information on determining problems.
LED Label Color Meaning