Service manual

Installing and Connecting the 2640 SAN Router
2-19
SAN Router Firmware Default Values
If you need to restore the default values in the firmware, review
Tabl e 2-9 as the table lists all default values and how you can change
or view the default values from Element Manager or SANvergence
Manager.
.
Table 2-9 SAN Router Firmware Default Values via Element Manager
Element Manager Parameters Default Setting Element Manager Menu Hierarchy
System
SAN Routing Cluster ID 1 Configuration>System>Operations
Enable remote access via Telnet Enabled Configuration>System>Operations
Router inband address 0.0.0.0 Configuration>System>Inband
Address
Router Subnet mask 0.0.0.0 Configuration>System>Inband
Address
Default Gateway address 0.0.0.0 Configuration>System>Inband
Address
SNMP Read-only Password public Configuration>System>SNMP
Communities/Hosts
SNMP Read-modify Password private Configuration>System>SNMP
Communities/Hosts
SNMP hosts None defined Configuration>System>SNMP
Communities/Hosts
SNMP Traps None defined Configuration>System>SNMP Traps
SNTP Disabled Configuration>System>Date/Time
New Device Zoning Not a member of
any zone
Configuration>System>New Device
Zoning
Element Manager Poll Interval (in
secs)
5 Options>Poll Interval
10/100 BaseT Management Port