Service manual

2-18
McDATA Eclipse 2640 SAN Router Installation and Service Manual
Installing an SFP Device
SFP transceivers are usually shipped with protective rubber plugs
installed. If you do not plan to immediately connect fiber cable to the
SFP after installation, leave the protective plugs installed.
To connect an SFP device, follow these steps:
1. Insert the SFP through the port cover into the connector until the
connector is firmly connected to the SFP. You should hear an
audible click as it snaps into place.
2. Remove the protective plugs.
3. Install the fiber cabling.
6 Rx-
7 Not used 100 Ω termination
8 Not used 100 Ω termination
Table 2-8 RJ45 Pinout Description
Pin Number Signal Comment