Service manual

2-16
McDATA Eclipse 2640 SAN Router Installation and Service Manual
ATTENTION! Do not block ventilation openings as this will restrict air flow
around the side and front of the unit. Do not install the SAN Router in an
environment where the operating ambient temperature might exceed 104°F
(40°C).
Management Port Pinouts
The SAN Router has two management port connectors, an RS-232
serial connector, and an RJ45 connector.
Serial Port Pinout
Figure 2-6, Serial Port Pinout and Ta bl e 2-7, Serial Port Pinout
Description describe the serial port pinout for the SAN Router.
Figure 2-6 Serial Port Pinout
Table 2-7 Serial Port Pinout Description
Pin Number Signal Comment
1 DCD Not used in the SAN Router.
2 RxD Input of the SAN Router.
3 TxD Output of the SAN Router.
4 DTR Output of the SAN Router.
5 Ground
6 DSR Not used in the SAN Router.