Service manual

Installing and Connecting the 2640 SAN Router
2-9
Task 6: Preparing the 2640 SAN Router for Element Manager
Access
Set the IP Address
for the Network
Management Port
Using CLI
The SAN Router has a 10/100 Management Port IP address. You need
to configure the SAN Router inband IP address. You do not need to
change the 10/100 Management Port IP Address for Element
Manager Access, but it must be set to an IP address appropriate for
the network before the SAN Router is managed by SANvergence
Manager. If you do not choose to set the 10/100 Management Port IP
Address now (with the CLI) you can do so from the Element Manager
later.
Changes made to the management port IP address will take effect
only after a SAN Router reset (CLI command reset system or Element
Manager File\Reset System).
The management port IP address is not affected by resetting the SAN
Router to defaults. The management port IP address and its
parameters (permanent route) remain the same until you actively
change it using either the CLI or the Element Manager.
Out-of-Band
Management
The 10/100 Ethernet Out-of-Band Management port provides for
out-of-band IP-based management. This interface allows simple
network management protocol (SNMP), Telnet, and web-based
management traffic to be separated from storage traffic through use
of a separate LAN. The IP address of the management port must be in
a different subnet than the SAN Router Inband IP address.
Set the management IP address using the CLI:
1. Press the Enter key to display the CLI prompt.
2. Logon to the SAN Router. Type modify at the Access Mode
prompt and private at the Password (community string) prompt.
3. Set or change management port IP address using the CLI:
• At the command prompt enter:
set mgmt portaddr <IP address><subnet mask>
where:
IP address = IP address of the management port
subnet mask = subnet mask of the management port (optional)
4. Set a permanent route to the network management station.