Service manual

2-8
McDATA Eclipse 2640 SAN Router Installation and Service Manual
• Connect female end of cable to the RS-232 port on the SAN
Router.
• Connect the male end of the cable to the RS-232 port on the
terminal.
Figure 2-2 Management Port to Management Terminal Connection
2. Set the PC terminal emulator settings to the SAN Router default
settings shown below in
Table 2-4.
Ensure that the VT100 arrow emulation feature is on.
Table 2-4 Terminal Emulator Settings
Parameter Setting
Bits per second 9600
Data bits 8
Parity bits None
Stop bits 1
Flow Control None