Service manual

Installing and Connecting the 2640 SAN Router
2-7
To set the SAN Router IP address, you can connect a terminal to the
RS-232 port on the SAN Router or access the SAN Router via Telnet
or embedded Web-based management on the 10/100 management
port using the default management IP address.
Task 5: Connecting the VT100 or Emulation Terminal to the RS-232
Management Port
To connect the terminal:
1. Use a null modem cable to connect a VT100 terminal or any
standard PC running terminal emulation software to the RS-232
serial port (
Figure 2-2) on the SAN Router.
Table 2-2 Default Management and SAN Router Addresses
Port IP Address Subnet Mask Default Gateway
Mgmt 192.168.100.100 255.255.255.0 0.0.0.0
Table 2-3 Other Defaults
Parameter Default Setting
Zoning No zone (No devices zoned by default)
iFCP SAN ID 0
FC Port Type FC - Auto
Intelligent Port Interface Depends upon the configuration purchased.
Intelligent Port Type Depends upon the configuration purchased.
E_Port Zone Policy Append router zones
Compression Off
MTU Auto
Auto Reset on Severe Errors Enabled
Fast Write Off
Serial Port 9600, 8, none,1, none