Service manual

2-6
McDATA Eclipse 2640 SAN Router Installation and Service Manual
Figure 2-1 2640 Ports and LEDs
Task 4: Preparing to Configure the 2640 SAN Router
You must first change the Management Port IP address through the
CLI as described in
Task 5: Connecting the VT100 or Emulation Terminal
to the RS-232 Management Port, page 2-7 and Task 6: Preparing the 2640
SAN Router for Element Manager Access, page 2-9.
Table 2-2 and Table 2-3 list and describe the default settings for the IP
SAN Router.
Refer to Table 2-2 for the default setting for the Management Port IP
address, which is the only IP address that must be changed using CLI
to provide access for out-of-band management. All other default
settings, shown in
Table 2-3 can be changed using the Element
Manager.
For a complete list of default values, review SAN Router Firmware
Default Values, page 2-19