Service manual

Installing and Connecting the 2640 SAN Router
2-5
The SAN Router has no power switch and powers up when
connected to a live power source. Either power supply can maintain
power for the SAN Router, however we recommend connecting both
power supplies, each to a separate power source for redundancy
protection.
To power up the SAN Router:
1. Locate the power connections at the rear of the SAN Router. See
Figure 1-2, The 2640 SAN Router, Rear View.
DANGER
Use the supplied power cords. Ensure the facility power receptacle is
the correct type, supplies the required voltage, and is properly
grounded. (D004)
2. Connect the power cord to the SAN Router and to a live power
outlet.
3. Repeat for the second power cord.
NOTE: You should maintain reliable grounding (earthing) of the
rack-mounted equipment. Pay particular attention to the supply connections
other than the direct connections to the branch current (for example, when
using power strips)