Service manual

Installing and Connecting the 2640 SAN Router
2-3
• SAN Router inband address.
FC host information:
• Platform version and patch/service pack level (Windows, Solaris,
etc.).
• HBA vendor, model, driver version, topology setting (Pt-Pt,
Loop, etc.).
FC Target information:
• FC target/array model, firmware version, drive details.
• SCSI bridge vendor, model, (Crossroads, etc.) and SCSI device
details.
FC Sub-fabric interconnect information:
• FC device or switch vendor, model, firmware version,
interconnect mode, domain ID, active zoneset.
iSCSI initiator information:
• IP address for initiator NIC interface.
•NIC hardware driver version.
• iSCSI initiator software vendor, version.
SAN application information:
• Vendor, version, and platform of management station details
(Windows, Solaris, etc.).
• Examples: TrueCopy, SAN copy, Mirrorview, SRDF,
PowerPath, etc.
Cabling and transceiver information:
• Cable vendor, cable type (Multimode/single mode,
shortwave/longwave), length and connector type (LC, SC, etc.).
• Transceiver: vendor, type (SFP, GBIC), FC (1063MBd), GE
(1250MBd) or tri-mode (both).
IP SAN Router/router information:
• Vendor, model, firmware version, Layer 2 - Layer 3, VLANS,
jumbo frame support, IP gateway address (hop) etc.
iFCP/iSCSI network details: