Service manual

2
2-48
Intrepid® 6140 Director Installation and Service Manual
Installation Tasks
• User ID - Type a unique user ID for the new user.
• Secure password - Typeapasswordupto16alphanumeric
characters in length. Control characters and spaces are not
valid. The password is case-sensitive.
• Retype Password - To confirm the password, enter the
password exactly as in the Secure Password field.
7. To enable e-mail notification for the new user, select (click) the
Enable check box. An unchecked box indicates e-mail notification
is not enabled.
8. To configure event types for which e-mail notification is sent,
select (click) the Filter
link.The Define Filter dialog box displays.
For instructions on defining event filters, refer to the SANavigator
Software Release 4.2 User Manual (621-000013) or EFC Manager
Software Release 8.7 User Manual (620-000170).
9. Click OK to accept the information. Close all dialog boxes and
return to the SANavigator or EFCM main window.
Task 13: Configure the Director to the Management Application
To manage a new director, it must be identified to and discovered by
the SAN management application. To identify the director:
1. At the SANavigator or EFCM main window, select Setup from the
Discover menu. The Discover Setup dialog box displays.
2. Click Add.TheAddress Properties dialog box displays with the IP
Address page open by default (Figure 2-24).
3. Type a director description in the Description field.
4. Type the director IP address (determinedby the customer) in the
IP Address field.
5. Type the director subnet mask (determined by the customer) in
the Subnet Mask field.
6. Click OK to save the entered information and define the director
to the SAN management application. Close all dialog boxes and
return to the SANavigator or EFCM main window.