Service manual

2
Installation Tasks
2-39
Installation Tasks
2. At the PC, enter the LAN 2 IP address of the server, followed by
:5800, as the Internet uniform resource locator (URL). Use the
following format:
http://xxx.xxx.xxx.xxx:5800
Where xxx.xxx.xxx.xxx is the default IP address of 10.1.1.1 or the
IP address configured while performing Task 7: Configure Server
Password and Network Addresses on page 2-36. The VNC
Authentication screen displays.
3. Type the default password and click OK.TheWelcome to Windows
dialog box displays.
NOTE: The default TightVNC viewer password is password.
4. Click the Send Ctrl-Alt-Del button at the top of the window to
log on to the server desktop. The Log On to Windows dialog box
displays.
NOTE: Do not simultaneously press the Ctrl, Alt,andDelete keys. This
action logs the user on to the browser-capable PC, not the server.
5. Type thedefault Windows username andpasswordandclick OK.
Theserver Windowsdesktopopensand theSANavigatorLogInor
EFCM Log In dialog box displays.
NOTE: The default Windows user name is Administrator and the
default password is password.Botharecase-sensitive.
Configure Management Server Names
To configure the management server name and workgroup name:
1. At the Windows desktop, click Start attheleftsideofthetaskbar
(bottom of the desktop), then sequentially select Settings, Control
Panel,andSystem.TheSystem Properties dialog box displays with
the General tab open by default.
2. Click the Network Identification tab. The System Properties dialog
box displays with the Network Identification tab selected.
3. Click Properties.TheIdentification Changes dialog box displays
(Figure 2-17).