Service manual

2
2-36
Intrepid® 6140 Director Installation and Service Manual
Installation Tasks
8. When the power cord is connected, the server powers on and
performs power-on self-tests (POSTs). During POSTs:
a. The green liquid crystal display (LCD) panel illuminates.
b. The green hard disk drive (HDD) LED blinks momentarily,
and processor speed and random-access memory information
display momentarily at the LCD panel.
c. After a few seconds, the LCD panel displays a Boot from
LAN? Press <Enter> message.
d. Ignorethe message. After ten seconds, theserver performs the
boot sequence from the basic input/output system (BIOS).
After successful boot and POST completion, the LCD panel
displays a Welcome!! message.
e. The server then continuously cycles through and displays the
operational information at the LCD panel.
9. Press the left edge (PUSH label) of the LCD panel to disengage
the panel and expose the CD-RW drive. Insert a blank rewritable
CD into the CD-RW drive and close the panel.
Task 7: Configure Server Password and Network Addresses
Verify the LAN installation. If the server is installed on a dedicated
LAN, network information does not require change. Change the
default password for the server LCD panel (if required by the
customer), then go to Task 8: Configure Management Server Information
on page 2-38.
If the server or equipment cabinet is installed on a public LAN, the
default password for the server LCD panel and the following
transmission control protocol internet protocol (TCP/IP) network
information must be changed to conform to the customer LAN
addressing plan:
• IP address.
•Subnetmask.
Configure Password
To configure a new LCD panel password: