Service manual

2
2-32
Intrepid® 6140 Director Installation and Service Manual
Installation Tasks
Figure 2-15 Connection Description Dialog Box
5. Type a descriptive director name in the Name field and click OK.
The Connect To dialog box displays.
6. Ensure the Connect using field displays COM1 or COM2
(depending on the port connection to the director), and click OK.
The COMn Properties dialog box displays, where n is 1 or 2.
7. Configure Port Settings parameters:
— Bits per second - 115200.
— Data bits - 8.
— Parity - None.
— Stop bits - 1.
— Flow control - Hardware or None.
Click OK.TheNew Connection - HyperTerminal window displays.
8. At the > prompt, type the user password (default is password)
and press Enter. The password is case sensitive. The New
Connection - HyperTerminal window displays with software and
hardware version information for the director, and a C>prompt
at the bottom of the window.
9. At the C>prompt, type the ipconfig command and press the
Enter key. The New Connection - HyperTerminal window displays
with configuration information listed:
— MAC Address.