Service manual

2
Installation Tasks
2-23
Installation Tasks
Enable CLI
Perform this procedure to toggle (enable or disable) the state of the
director command line interface (CLI). To change the CLI state:
1. Select CLI from the Configure menu at any view. The CLI View
displays (Figure 2-11).
2. Perform one of the following:
• Click Enable to activate the CLI.
• Click Disable to deactivate the CLI.
3. Check the Use SSH check box to enable secure shell (SSH)
protocol. The protocol controls CLI access to the director and
provides software-enforced encryption.
4. Click OK to save and activate changes.
Figure 2-11 CLI View
Enable or Disable Host Control
Perform this procedure to toggle (enable or disable) host control of
the director through the OSMS. The OSMS PFE key must be installed
(Install PFE Keys (Optional) on page 2-25). To enable or disable OSMS
and host control:
1. Select OSMS from the Configure menu at any view. The OSMS
View displays (Figure 2-12).
2. Perform one of the following:
• Click Enable to activate OSMS.