Service manual

2
Installation Tasks
2-19
Installation Tasks
3. Update the address resolution protocol (ARP) table for the
browser PC.
a. Close the EFCM Basic Edition interface and all browser
applications.
b. At the Windows desktop, click Start attheleftsideofthetask
bar. The Windows Workstation menu displays.
c. At the Windows Workstation menu, sequentially select the
Programs and Command Prompt options. A disk operating
system (DOS) window displays.
d. Delete the director old IP address from the ARP table. At the
command (C:\)prompt,typearp -d xxx.xxx.xxx.xxx,where
xxx.xxx.xxx.xxx is the old IP address for the director.
e. Click close(X) at the upperrightcorner of theDOSwindowto
close the window and return to the Windows desktop.
4. Perform a power-on reset (POR) (IML, IPL, or Reset the Director on
page 4-38).
5. At the PC, launch the browser application (Internet Explorer or
Netscape Navigator). Enter the director new IPaddressasthe
Internet URL. The Enter Network Password dialog box displays.
6. Type the case-sensitive user name and password and click OK.
The EFCM Basic Edition interface opens and the To polo gy Vi ew
displays with status information about each fabric element.
Configure Basic Port Information
Perform this procedure to configure basic port information.
1. Select Ports and Basic Info from the Configure menu at any view.
The Basic Information View displays (Figure 2-9).
a. For each port to be configured, type a port name of 24
alphanumeric characters or less in the Name field. The port
name should characterize the device to which the port is
attached.
b. Click a check box in the Blocked column to block or unblock a
port (default is unblocked). A check mark in the box indicates
aportisblocked.