Service manual
2
2-18
Intrepid® 6140 Director Installation and Service Manual
Installation Tasks
Configure Network Information
Verify the LAN installation with the network administrator.
• If one director is installed on a dedicated LAN, network
information(IPaddress, subnet mask,andgateway address)does
not require change.
• If multiple directors are installed or a public LAN segment is
used, network information must be changed to conform to the
LAN addressing plan.
Perform this procedure to change director network information.
1. Select Switch and Network from the Configure menu atany view.
The Network View displays (Figure 2-8).
Figure 2-8 Network View
a. At the IP Address field,typethenewvalue(defaultis
10.1.1.10).
b. At the Subnet Mask field, type the new value (default is
255.0.0.0).
c. At the Gateway Address field, type the new value (default is
0.0.0.0).
2. Click OK to save and activate changes. An acknowledgement
message displays,indicating the browser PC must be directed to
the new IP address.