Service manual

2
2-6
Intrepid® 6140 Director Installation and Service Manual
Installation Tasks
• An Internet connection to a browser-capable PC (EFCM Basic
Edition interface). Connection of a LAN segment with multiple
products to the Internet may require installation of a 24-port
Ethernet hub.
Follow the instructions in Unpack and Inspect Ethernet Hub below to
unpack, inspect, and install the Ethernet hub, but:
• If the existing Ethernet LAN segment is adequatefor connectivity
andahubisnotdelivered,thistaskisnotrequired.GotoTa sk 3 :
Unpack, Inspect, and Install the Director on page 2-9.
• If the hub is delivered in a Fabricenter equipment cabinet, go to
Task 5: Configure Director Network Information (Optional) on
page 2-30.
Unpack and Inspect Ethernet Hub
Unpack and inspect the Ethernet hubs.
1. Inspect shipping containers for damage. If a container is
damaged, ensure a freight-carrier representative is present when
the container is opened. Unpack shipping containers and inspect
each item for damage. Ensure packaged items correspond to
items listed on the bill of materials.
2. If items are damaged or missing, contact the solution center:
Phone: [phone] or [phone]
Fax: [phone]
E-mail: [e-mail]
Desktop Installation
To install and configure up to three Ethernet hubs on a desktop:
1. Removethebackingfromthefouradhesiverubberpadsand
apply the pads to the underside of each hub. Ensure pads are
aligned with the scribed circles at each corner.
2. Position the first hub on a table or desktop. Stack the remaining
hubs on top of the first hub. Ensure the adhesive rubber pads on
the underside of a hub align with the recesses on the top of the
hub below.
3. To daisy-chain (connect) the hubs: