Service manual

1
Tools and Test Equipment
1-15
General Information
Tools and Test Equipment
This section describes tools and test equipment that may be required
to test, service, and verify operation of the director and attached
management server. These tools are either supplied with the director
or must be supplied by service personnel.
Tools Supplied with
the Director
The following tools are supplied with the director. Use of the tools
may be required to perform installation, test, service, or verification
tasks.
• Torque tool with hexagonal adapter - Thetorquetoolwith5/32”
hexagonal adapter (Figure 1-8)isrequiredtoremoveandreplace
director logic cards.
ATTENTION! The torque tool supplied with the director is designed to
tighten director logic cards and is set to release at a torque value of six
inch-pounds. Do not use an Allen wrench or torque tool designed for use
with another McDATA product. Use of the wrong tool may overtighten and
damage logic cards.
Loading firmware The system is busy loading new firmware, but the
system is otherwise operational.
Not operational A critical failure has occurred that prevents the
director from performing fundamental switching
operations.
o Link time-out
oProtocol
mismatch
o Never connected
Director status is unknown. Occurs is network
connection between the management server and the
director is lost, or if a CTP card fails and there is no
operational backup, or if there is no system power.
Table 1-1 Element Manager Alert Symbols, Messages, and Status ( continued )
Symbol Message Description