Service manual

A
CTP Card Events (400 through 499)
A-47
Event Code Tables
Event Code: 442
Message: Embedded port anomaly detected.
Severity: Informational.
Explanation: The CTP card detected a deviation in the normal operating mode or status of the embedded port.
Action: No action required. Additional event code is generated if incident exceeds error threshold or causes a port failure.
Event Data: Byte 0 = port number. Byte 12 = detecting port.
Byte 1 = engineering reason code. Byte 13 = connected port.
Bytes 4 - 7 = elapsed millisecond tick count. Byte 14 = participating SBAR.
Bytes 8 and 9 = high-availability error callout #1. Bytes 16 and 17 = high-availability error callout #3.
Bytes 10 and 11 = high-availability error callout #2. Bytes 18 and 19 = high-availability error callout #4.
Distribution: Director Management Server Host
Nonvolatile
System
Event Log
System
Error LED
Event Log E-Mail Call-Home Sense Info Link Incident
Event Code: 450
Message: Serial number mismatch detected.
Severity: Informational.
Explanation: This event occurs when the sequence number or OEM serial number in the system VPD (read from the
backplane) does not match the sequence number and serial number that was saved in NVRAM the last time the
director was IPLed. This event will occur normally when a CTP is moved from one switch to the master position of
another switch. This event may occur abnormally when a hardware problem causes a problem reading the
system VPD from the backplane.
Action: None. Any configured feature keys will be cleared. Configuration information will be synched with the backplane
VPD, and the CTP will automatically be IPLed.
Event Data: Bytes 0 - 12 = sequence number from the system VPD.
Bytes 13 - 31 = OEM serial number from the system VPD.
Distribution: Director Management Server Host
Nonvolatile
System
Event Log
System
Error LED
Event Log E-Mail Call-Home Sense Info Link Incident