Service manual

5-40

Intrepid® 6140 Director Installation and Service Manual

Removal and Replacement Procedures (RRPs)

RRP: Backplane

Use the following procedures to remove or replace the backplane. A

list of tools required is provided.

Tools Required The following tools are required to perform these procedures.

• Door key with 5/16-inch socket (provided with the FC-512

Fabricenter equipment cabinet).

• Torque tool and hex adapter (provided with the director).

• Standard flat-tip screwdriver.

• Standard cross-tip (Phillips) screwdriver.

• ESD grounding cable and wrist strap.

• Maintenance terminal (desktop or notebook PC) with:

— The Microsoft Windows 98, Windows2000, Windows

Millennium Edition, or Windows NT 4.0 operating system.

— RS-232 serial communication software (such as ProComm

Plus or HyperTerminal). HyperTerminal is provided with

Windows operating systems.

• Asynchronous RS-232 null modem cable (provided with the

director).

Removal To remove the backplane:

1. At the Hardware View, double-click the graphic representing the

director bezel (do not click a graphical FRU) to open the Director

Properties dialog box. Record the director serial number. This

number must be programmed into the replacement backplane.

If the director is not communicating with the management server

(Director Properties dialog box is not available), obtain the serial

number while performing step 5.

2. Notify the customer that the director will be powered off. Ensure

the customer system administrator quiesces Fibre Channel frame

traffic through the director and sets attached devices offline.

3. If the director is installed in a stand-alone configuration, go to

step 4. If the director is rack-mounted, perform one of the

following: