Service manual

RRP: Power/System Error LED Assembly

5-35

Removal and Replacement Procedures (RRPs)

Figure 5-9 Power/System Error LED Assembly Removal and Replacement

Replacement To replace the Power/System Error LED assembly:

1. Remove the replacement Power/System Error LED assembly

from its protective anti-static bag.

2. Replace the Power/System LED assembly.

3. Plug the Power/System LED assembly cable into the backplane.

4. Replace the center and upper left fan modules (viewed from the

rear) (RRP: Fan Module on page 5-30).

5. Disconnect the ESD wrist strap from thedirector chassis and your

wrist.

6. Replace the RFI shield.