Service manual

5-26

Intrepid® 6140 Director Installation and Service Manual

Removal and Replacement Procedures (RRPs)

RRP: AC Module

Use the following procedures toremove or replace the ACmodule. A

list of tools required is provided.

Tools Required The following tools are required to perform these procedures.

• Door key with 5/16-inch socket (provided with the FC-512

Fabricenter equipment cabinet).

• Standard cross-tip (Phillips) screwdriver.

• ESD grounding cable and wrist strap.

Removal To remove the AC module:

1. If the director is installed in a stand-alone configuration, go to

step 2. If the director is rack-mounted, perform one of the

following:

— If the director is installed in a McDATA-supplied FC-512

Fabricenter equipment cabinet, insert the 5/16" door tool into

the socket hole at the right top of the rear door. Turn the tool

counter-clockwise to unlock and open the door.

— If the director is installed in a customer-supplied equipment

cabinet, unlock and open the cabinet rear door as directed by

the customer representative.

DANGER

Disconnect the power cords.

ATTENTION! Do not remove the power cord from the operational AC

module.

2. Disconnect the power cord from the defective AC module.

ATTENTION! To avoidcausing machine errorsor damagewhileworkingon

the director, follow ESD procedures by connecting a grounding cable to the

director chassis and wearingan ESD wrist strap.

3. Follow ESD procedures by attaching a wrist strap to the director

chassis and your wrist (Figure 5-1).