Service manual

5-24

Intrepid® 6140 Director Installation and Service Manual

Removal and Replacement Procedures (RRPs)

Figure 5-6 Power Supply Removal and Replacement

5. Pull the power supply from the director AC module (Figure 5-6).

Support the power supply with one hand.

6. Place the power supply in an anti-static bag to provide ESD

protection.

Replacement To replace a power supply:

1. Remove the replacement power supply from its protective

anti-static bag.

2. Inspect the rearof the power supply for bent or broken connector

pins that may have been damaged during shipping. If any pins

are damaged, obtain a new power supply.

3. Insert the power supply into the chassis guide of the AC module,

then push the power supply toward the backplane to engage the

connector pins.

4. Disconnect the ESD wrist strap from thedirector chassis and your

wrist.