Service manual

5
5-18
Intrepid® 6140 Director Installation and Service Manual
Removal and Replacement Procedures (RRPs)
7. Disconnect the fiber-optic jumper cable from the port:
a. Pull the keyed LC free from the port optical transceiver.
b. Place a protective cap over the cable connector.
8. Dependingon the manufacturer, the opticaltransceivermay have
a locking mechanism to secure the transceiver in the port
receptacle, or the transceiver may have a pull tab to assist in
removal.
a. If required, disengage the locking mechanism (usually at the
left side of the transceiver) by squeezing the mechanism or
pushing it toward the port receptacle.
b. Grasp the pulltab or theopticaltransceiver frame and pull the
transceiver from the port receptacle (Figure 5-4).
Figure 5-4 SFP Optical Transceiver Removal and Replacement
Replacement To replace an SFP or XFP optical transceiver:
1. Remove the transceiver from its packaging.
2. Insert the transceiver into the port receptacle (Figure 5-4).