Service manual

5
5-8
Intrepid® 6140 Director Installation and Service Manual
Removal and Replacement Procedures (RRPs)
Figure 5-2 CTP Card Removal and Replacement
Replacement To replace a CTP card:
1. Wait approximately 20 seconds after removal of the failed CTP
card to begin this replacement procedure.
2. Remove the replacement card from its protective anti-static bag.
3. Hold the card by its stiffener and insert it in the chassis card track
(Figure 5-2). The label identifying the card should be at the top.
Verify the card is aligned in the card tracks, then slide it forward
until it makes contact with the backplane.
4. Secure the CTP card:
a. InsertthetorquetoolintothecamAllenscrewatthetop ofthe
card. Turn the torque tool clockwise until you feel it release
and hear a clicking sound. As the screw turns clockwise, the
card cams into the backplane connector.
b. Insert the torque tool into the locking Allen screw at the
bottom of the card. Turn the torque tool clockwise until you
feel it release and hear a clicking sound. As the screw turns
clockwise, the card locks into place.