Service manual

4
4-56
Intrepid® 6140 Director Installation and Service Manual
Repair Information
5. Click OK to reset the configuration. The message "Your changes
have been successfully activated." appears.
6. The IP address resets to the default of 10.1.1.10.
— If the configured IP address (prior to reset) was the same as
the default, the browser-to-director Internet connection is not
affected and the procedure is complete.
— If the configured IP address (prior to reset) was not the same
as the default, the browser-to-director Internet connection
drops and the EFCM Basic Edition session is lost. Continue to
the next step.
7. To change the director IP address and restart the EFCM Basic
Edition interface,see Task 5: ConfigureDirector Network Information
(Optional) on page 2-30. To restart the EFCM Basic Edition
interface using the default IP address of 10.1.1.10:
a. At the browser, enter the default IP address of 10.1.1.10 as the
Internet URL. The Enter Network Password dialog box displays.
b. Type the default user name and password.
NOTE: The default user name is Administrator and the default
password is password. Theusernameandpasswordare
case-sensitive.
c. Click OK. The EFCM Basic Edition interface opens and the
procedure is complete.