Service manual

4
Managing Configuration Data
4-53
Repair Information
Figure 4-21 Address Properties Dialog Box
e. Type 10.1.1.10 in the IP Address field and click OK.Entriesat
the Discover Setup dialog box reflect the new IP address.
f. At the Discover Setup dialog box, click OK. Director-to-
management server communication is restored and the
procedure is complete.
8. Change the director IP address and restart the management
server session as follows:
a. A grey square with a yellow exclamation mark appears
adjacent to the icon representing the reset director, indicating
director is not communicating with the management server.
a. Delete the icon representing the reset director. At the SAN
management application, select Setup fromthe Discover menu.
The Discover Setup dialog box displays (Figure 4-20).
b. Select the entry representing the reset director in the Available
Addresses window and click Remove.
c. At the Discover Setup dialog box, click OK. The director is no
longer defined to the management server.
d. Change a director IP address through the maintenance port
(Task 5: Configure Director Network Information (Optional) on
page 2-30).
e. Identify the switch to the SAN management application (Tas k
13: Configure the Director to the Management Application on
page 2-48).