Service manual

4-34

Intrepid® 6140 Director Installation and Service Manual

Repair Information

3. Insert a blank diskette in the floppy drive of the PC

communicating with the EFCM Basic Edition interface.

4. At the Save As dialog box, select the floppy drive (A:\)fromthe

Save in drop-down menu, type a descriptive name for the zipped

(.zip)dumpfileintheFile name field, and click Save.

5. A Download dialog box displays, showing the estimated time

remaining to complete the download process. When finished, the

dialog box changes to a Download complete dialog box.

6. Click Close to close the dialog box.

7. Remove the diskette with the newly-collected maintenance data

from the PCfloppy drive. Return the diskette with the failed FRU

to support personnel for failure analysis.

Powering the Director On or Off

This section describes procedures to power on or power off the

director.

Power-On Procedure

DANGER

Use the supplied power cords. Ensure the facility power receptacle is

the correct type, supplies the required voltage, and is properly

grounded.

To power on the director:

1. One alternating current (AC) power cord is required for each

power supply installed. Ensure power cord(s) connect facility

power to the input AC module at the bottom rear of the director.

NOTE: If two power cords are installed for high availability, plug the

cords into separate facility power circuits.

NOTE: The director does not have a power switch. Therefore the

director powers on when its power cords are connected to facility power.